1/4 in. bore zinc-plated mild steel set screw collar,Introduction to 1/4 in. bore zinc - plated mild steel set screw collar A 1/4 in. bore zinc - plated mild steel set scre
Introduction to 1/4 in. bore zinc - plated mild steel set screw collar
A 1/4 in. bore zinc - plated mild steel set screw collar is a very useful little part in various mechanical or DIY applications. This type of set screw collar is made of mild steel, which is known for its durability and strength. The zinc - plating on it serves multiple purposes. It not only gives the collar a nice, shiny appearance but also provides protection against rust and corrosion.
In practical use, you can find these set screw collars in machinery where they are used to hold shafts in place. For example, in a small workshop, if you have a shaft that needs to be precisely located within a housing, this collar can be tightened around the shaft at the desired position. It's a simple yet effective way to control the movement or position of a component.
Advantages of the Zinc - Plating
The zinc - plating on the 1/4 in. bore mild steel set screw collar is really a great feature. One of the main advantages is that it extends the life of the collar. Without the plating, the mild steel would be more susceptible to rust, especially in humid or wet environments. In a garage or a factory near the ocean where there is a lot of moisture in the air, the zinc - plated collar can resist the corrosive effects much better.
Another advantage is that the zinc - plating makes the collar easier to clean. Grease, dirt, and other contaminants don't stick to it as easily as they would to un - plated steel. This is important in a maintenance - heavy environment where you need to keep your equipment clean and in good working order.
Installation and Use
Installing a 1/4 in. bore zinc - plated mild steel set screw collar is a relatively straightforward process. First, you need to slide the collar onto the shaft at the appropriate location. Then, you use a screwdriver to tighten the set screw. It's important to make sure that the set screw is tightened enough to hold the collar firmly in place but not so tight that it damages the shaft.
When using these collars, it's also crucial to consider the load and stress that will be applied to them. If you're using them in a high - load application, you may need to check and tighten them periodically to ensure they continue to function properly. For example, in a conveyor belt system where the shafts are constantly rotating and under some stress, these collars need to be in good condition.
Questions and Answers
Question 1: Where can I use the 1/4 in. bore zinc - plated mild steel set screw collar?Answer: You can use it in machinery to hold shafts in place, such as in a small workshop for precisely locating a shaft within a housing or in a conveyor belt system.
Question 2: Why is the zinc - plating important for the 1/4 in. bore mild steel set screw collar?Answer: The zinc - plating is important because it extends the life of the collar by protecting against rust and corrosion, and it also makes the collar easier to clean as contaminants don't stick to it as easily.
Below is,1/4 in. bore zinc-plated mild steel set screw collarpartial price list| Category | Market Price | Use Cases |
| 430 stainless steel sheet | 1053$/Ton | Automobile shells, body parts |
| 316 stainless steel cost | 1079$/Ton | Storage, transportation |
| 18k gold plated stainless steel tarnish | 1097$/Ton | Storage, transportation |
